Kleenoil Super Duty Filter Unit

The Kleenoil filtration unit is made of cast aluminum with a galvanized steel mounting bracket. There are three basic sizes, which are installed according to the applications table below. It is connected to the engine lubricating oil circulating system in a bypass loop using high pressure braided hose and fittings to SAE standards.

The Kleenoil By-Pass Filter takes a small percentage of the normal oil flow, filters out abrasive particles such as carbon, wear metals and silicon, and totally removes water. 90% of engine wear is caused by acids, formed when the sulphurous by-products of combustion mix with water in the oil. By removing these impurities as they occur, the Kleenoil Filter prevents the build-up of acid and maintains the oil within its operating specifications. The installation of a Kleenoil By-Pass Filter enables the recommended oil change frequencies to be extended by up to 10 times.

The Kleenoil Hydraulic Block is mounted to the bottom of the Kleenoil Bypass Filtration System to convert the lower pressure bypass engine oil filter to a high pressure hydraulic fluid filter.

There are three ports on the valve block as listed:

• Port 1: Low Pressure output approximately 50 PSI normally is blanked off but may be used to supply another filter housing
• Port 2: High pressure input up to 3000 PSI
• Port 3: Return to hydraulic reservoir. This port is fitted with adaptors size No. 6 JIC and it is important that the return hose is of at least 3/8 bore ore than 70% of hydra

• Filtration Level: Particulate contamination in accordance with BS 5540 Part 4: 1981 and ISO/DIS 4406 14/9, equivalent to NAS 1638 Class 6 (Hydraulic Oil Specification).
• Water Retention: To <0.025%

• A dramatic reduction in component wear (seals, piston rods, pumps, etc).
• A reduction in the incidence of sticking and worn valve components.
• Extended life of in-line filters.
• An end to the need to change hydraulic fluids.
• The Kleenoil "High Pressure" oil filter can be fitted on the `by-pass` basis to hydraulic systems, compressors, or any system with oil at pressure up to 3000 PSI.
• The flow through the Kleenoil Filter is controlled to approximately 4 liters / minute at 40 PSI. This gives you a flow rate which is low enough to have negligible effects on most `System Pressures`, YET is high enough to ensure that oil is being kept in `as new` condition.
• For hydraulic systems with tanks up to 1360 liters / 300 gallons
• Uses Super Duty Cartridge (Code KF85) or 1888